Guernsey Milk

Full of A2 Goodness

HELLO MUM! Can your milk help Autism?

Click here for Property 1

Click here for Property 2

Click here for Property 3

Increase SizeDecrease SizeReset font to default

Unique Property of Guernsey Milk - 1

Beta Carotene - As this is not digested and broken down by Guernsey cows, it creates the wonderful golden colour in the milk and its products.

Unique Property of Guernsey Milk - 2

Omega 3 - Guernsey milk is naturally better balanced than other milks, with test results showing it to have one part omega 3 to two parts omega 6, whereas all other milks are one part omega 3† to six parts omega 6.

Unique Property of Guernsey Milk - 3

Beta Casein A2 - Guernsey milk has a naturally high percentage of Beta Casein A2 (tested to be more than 95% of A2). Other milks have shown to be between 40% (Jersey milk) and 15% (Holstein milk).
A Cheesemaker's tale, equipment - Part 4 PDF Print E-mail

Crikey, where on earth to start on this one?!

May I give a small tip: start looking as soon as possible if you need second-hand equipment as it is thin on the ground.

I started looking at new but it was too expensive for a tiny concern like mine although I still look at the photos and salivate. Imagine having a vat with an automatic stirrer!

Anyway, if you are on a limited budget, think second-hand and/or adapt things designed for other uses. One friend adapted a swimming pool heater to heat his milk.

My kitchen stock pot is my smallest vat. My smaller stirrers are from the kitchen drawer which drives my husband nuts but still..

Essential kit; letís start small;

Thermometer: this is under £12 from Ascott† Smallholdings or Moorlands† Cheesemakers, the dairy one with a round dial. The thin glass ones always seem to break and glass is a no no with commercial cheesemaking. I expect I may graduate on to a digital probe which will mean I donít have to hold it but this one is fine for the time being.

The stirring spoon has slots in it for the milk to pass through. From kitchen shops and stainless steel for sterilising (could be plastic).

The already mentioned stock pot has a lid and amount markings; very useful for small batches and my tiny amounts of curd cheese. I also pasteurise the goatsí milk in it. Itís just over 10 Litres.

Now; knives for cutting curd. Mine were quite expensive and always seem to cost a bit. You need two; horizontal and vertical. Books show you how to cut with a carving knife but I could never get cubes that way.

The vat is 100L and although small, will always be useful because when I graduate on to the big vat, I can still use this one for experimental batches. And it is so sweet. It is very simple. I recall Liz (who sold it to me) laughing when I asked where I could plug it in.. you canít. Itís a simple jacketed design where you pour hot water into the side and the milk inside the vat heats up..very slowly! Liz and her husband Neil were successful cheesemakers in Scotland and another cheesemaker told me they were closing so a lot of my equipment came from them plus ongoing advice and support which you cannot put a price on.

Thumbnail

Anyway, the big vat is from next door Alderney and needs to be adapted to please Guernsey Electricity when the lovely electrician has time to return! It came with a press and loads of Gouda moulds which will come in useful if I do Gouda! It looks like a 6ft coffin and the stirrer is a big plastic spade with holes in it.
I have 220 other moulds. Too many but you never know. You can cut up PVC piping and use that to save a lot of money but I like the holes in the side that mine have.

From Scotland too, came stackable drying racks which havenít really come into their own yet but will I hope. I think they are useful if you can simply push the unmoulded cheeses into a room to ripen but I havenít the space for that and they are not strong enough for the initial overnight draining when the cheese is very wet, heavy and still in the moulds. I also have plastic mats which I have cut up to help me turn the cheese more easily.

Thumbnail

Two long plastic draining tables came too. Very useful but the floor slopes so I have to lift the end to drain the whey through the hole at the end. Still loads to learn!

I am actually trying to buy heavy duty draining trays at the moment as my first two batches of camembert had to be chucked as they went slimy, smelly and blew up like balloons. A drainage problem Iím told! Three will cost about £250.

The double sink and drainer is great. Not a second-hand bargain though; it was second-hand but not cheap if you know what I mean.

Thumbnail

The dishwasher isnít essential but jolly nice as it cleans the moulds beautifully and saves lots of scrubbing.† Free from the dump!

The air-conditioning unit is Vyair and great so far. About £300.

Flyzapper (essential) only about £27.00.

Thumbnail

Also needed to buy a hand-wash sink with towel and soap dispenser.

The ceiling light is a strip light with plastic cover.

Fridges; I looked into humidity fridges but they are very expensive so I use old fridges (not from the dump; against health and safety regs. apparently) and for the humidity I put water into dishes in the base of the fridge. I do, however have fridge thermometers in all and have bought a humidity meter for checking the humidity occasionally. Fridge thermometers are cheap in kitchen shops.

Cheese culture has to be kept frozen so I have a fridge-freezer in the room too which is my proper cold fridge too.

The tap has a hose and shower connection; essential for rinsing off the sterilising solution.

Very useful and used all the time is a cheap plastic bucket.

I also have a large plastic basin which lies on the ground under the draining table. This was from Lakeland Plastics and is really for soaking oven trays but is very good for lots of things.

I have micro scales for measuring the minute weights of cheese culture and large scales for the finished product. The large scales†are Avery and were about £100. I love them. You feel like a child playing grocers with those! Trading standards had to look at them to check I wasnít going to diddle anyone.

Thumbnail

I also have a brine refractometer for checking salt concentration in the brine solution for the camembert. That makes me feel like a scientist especially with my white coat on....

Other expenses are point of sale things like a pricing gun, date stamper, label printer (Dymo) and Iíll go into the other labels and packaging another time.

I expect there are experienced cheesemakers out there who may think some of my choices are all wrong but I really have been in the dark a bit here and have grabbed what I can or have got the room for. Being a member of The Specialist Cheesemakersí Association has been so important too. They have a list of suppliers of equipment and ingredients and a list of members who are very helpful to each other. There are, after all, less than 500 cheesemakers out there. Often, too, their newsletter has details of equipment for sale.

Good luck!

Previous - Part 3 Next- Part 5

Comments (1)Comments are closed
1Friday, 12 March 2010 19:35
judi

Thank you for posting this.† I'm thinking of going into cheesemaking myself and very keen to understand what is necessary.† Getting the equipment seems like a challenge.† Will join the Specialist Cheesemakers right away!

†All the best,

Judi

Quote this article on your site

To create link towards this article on your website,
copy and paste the text below in your page.




Preview :

A Cheesemaker's tale, equipment - Part 4
Tuesday, 24 February 2009
Crikey, where on earth to start on this one?! May I give a small tip: start looking as soon as possible if you need second-hand equipment as it is...

© 2021 - Guernsey Milk


Powered by QuoteThis © 2008
 
image